Call our central office
+44 (0) 1489 583858
conTROL
The EMC operating enclosure
IP 66, Optional: IP 67
The key product features:
• Enclosure material: diecast aluminium
• Enclosure surface: powder coating, RAL 7032
• High inner collar
• Tooth system in the bottom section for continuous contact
• Cover with high protective collar
• Sizes compatible with standard enclosures available on the market, therefore easy to exchange
• Lid screws in stainless steel 1.4567
• Enclosure seal: TPE moulded gasket
Request offer
PDF datasheet
More
conTROL is a robust and versatile range of EMC shielded aluminium enclosures which is ideal for machine control equipment. The enclosures feature in-built shielding that does not require expensive and delicate conductive gaskets. Continuous contact is created by means of a patented tooth system pre-cast into the lid and base.
Standard features include a deep recessed lid which is designed to protect buttons and control switches. The enclosures are water-tight and weather resistant to IP 66. Threaded screw bosses are provided inside for fitting circuit boards, mounting plates, terminal rails etc. Accessories such as mounting plates and cable glands are also available.
We can supply conTROL enclosures fully customised to your requirements.
Product overview
Dimensions
Data Sheets
Data
- conTROL
- EKT 082
- Part No.
- 310.082.000
- Dimensions
- 85x130x78 Remember
- conTROL
- EKT 083
- Part No.
- 310.083.000
- Dimensions
- 85x180x78 Remember
- conTROL
- EKTF 082
- Part No.
- 311.082.000
- Dimensions
- 85x130x55 Remember
- conTROL
- EKTF 083
- Part No.
- 311.083.000
- Dimensions
- 85x180x55 Remember
130x85x78
180x85x78
130x85x55
180x85x55
| Enclosure sizes | 4 |
| Additional info | High shielding from radiation interference (EMC tested by the University of Hanover) Collar protects command and information buttons |
| Inexpensive, as there is no need for expensive conductive gaskets Large range of accessories | |
| Enclosure | Diecast aluminium alloy |
| EN AN-44300 DIN EN 1706 | |
| (GD Al Si 12/DIN 1725) | |
| 1° mould slope for casting ejection > internal circumference dimensions decrease by 1° towards enclosure bottom. | |
| Fastening | Separate screw channels outside of the enclosure interior |
| Console panel integration with installation kit | |
| Internal mounting | M4 fastening thread in lateral bars on the enclosure base and optional fastening on the lid |
| Ingress protection | IP 66 / EN 60529 |
| Optional: IP 67 / NEMA 4 | |
| Gasket | TPE moulded gasket, silicone-free |
| Optional: Silicone gasket | |
| Lid screws | Stainless steel 1.4567, captive |
| Surface | Powder coating RAL 7032, silky grey |
| Optional: Special colours | |
| Optional: Corrosion protection | |
| Customising | Learn more about our full customising service for installation-ready enclosures |